Connections
- 3.5mm stereo AUX input
- 3.5mm stereo AUX output
- Optical audio input
- Bluetooth on/off & Master volume
- Secondary Speaker outputs (IWA-415B only)
- Left + Right Speaker outputs
- Fig.8 mains power inlet
Installation
Locate the IWA-series amplifier in the ceiling, wall or on the surface
required. Tabs at each end of the housing can be used for securing with
screws.
Connect speakers using twin core speaker cable by connecting “+” and “-”
on the speaker to the relevant connection on the amplifier. The speaker
connections are via screw terminals on Euroblock terminals (5, 6), which
can be removed for easy access whilst making connections.
Important: Ensure that the load is no lower than 4Ω for each output.
(e.g. a 4Ω speaker on each output… or… a pair of 8Ω speakers wired in
parallel)
Ensure that the speakers can handle the rated output of the amplifier
at that load.
If the amplifier is to be used with a wired audio line level input
(instead of Bluetooth), connect this to the 3.5mm stereo jack labelled
“AUX IN” (1).
Any Bluetooth, Line in or Optical input playing through the amplifier
can be relayed to further amplifiers from a line output from the 3.5mm
stereo jack labelled “AUX OUT” (2).
AUX IN and AUX OUT connections should be made using
shielded stereo audio cable and not speaker cable.
Audio connections for the 3.5mm AUX IN and AUX OUT jacks are shown
opposite.
The Optical input (3) can accept digital audio from equipment with an
optical output.
Connect the digital audio optical output to the amplifier using a
suitable fibre-optic lead.
Connect power from the mains supply using the fig.8 power lead provided
or a suitable equivalent (7).
Operation
The Master volume control (4) can be adjusted using a small screwdriver,
with fully anti-clockwise being the minimum setting and fully clockwise
being the maximum output.
When first checking the system, it is safest to start with the volume
fully down before powering up and gradually increase until the required
volume is reached.
Beneath the Master volume control is a slide switch for Bluetooth
on/off. When this is switched on, the internal Bluetooth receiver will
always be open for pairing.
Search available Bluetooth devices on your smart phone or other sending
device for a device with Bluetooth ID “IWA215B-****”,
“IWA230B-****” or “IWA415B-****”
(where **** is a unique ID number for each unit).
Select to pair and connect with this ID.
When paired and connected, set the volume low on the smart phone or
other sending device and play a track to check the sound through the
speakers.
AUX input, Optical input and Bluetooth are all connected to the
amplifier equally. None will override any other and if 2 or more are
playing at once, they will all play through the speakers and AUX output.
Power down the amplifier when not in use and isolate from the mains if
not used for long periods.
